Used to read and change the parameters of the SENTRON WL and SENTRON VL circuit breakers, the Siemens Breaker Data Adapter Plus (BDA Plus) displays measured values, as well as visualizes, analyzes, and stores diagnostic data.
Read More »Rent the Siemens BDA Plus to Read and Change SENTRON Circuit Breakers
The Westrip RMS-2000 Logic Controller is highly flexible and has been designed to replace older trip devices.
Read More »Siemens Westrip Amptector Adapter Plug Added to Protec Rental Catalog
Secondary current injection testing is performed on solid-state trip units using a specially designed power supply unit. However, the secondary injection method only tests the solid-state trip unit, and does not test the current sensors, wiring, or the breaker current handling components.
Read More »Rent Secondary or Primary Current Injection Test Sets, the Best Option
The ABB Ekip Connect Secondary Injection Test Set is a software application for personal computers that interfaces with ABB low voltage circuit-breakers equipped with compatible protection releases. 
The test set allows the releases to be configured, monitored, controlled and tested. Ekip Connect can connect to the releases in the point-to-point or network modes, and connection is made using the front test connector or to communication modules installed on the circuit-breaker.
Read More »ABB Ekip Connect Secondary Injection Test Set Now for Rent from Protec
Square D by Schneider S33595 test applications include Secondary Injection, Manual Trip Curve, Automatic Trip Curve, Zone-Selective Interlocking, Ground-Fault and Thermal-Imaging Inhibit.
Read More »Rent Today from Protec – Square D S33595 Secondary Injection Test Set
The ABB TS3 Trip Unit Test Set verifies performance of the following Low Voltage ABB SACE air circuit breakers electronic trip units, with one-phase secondary current injection:
ABB SACE
Read More »Rent the ABB TS3 for Reliable Secondary Current Injection Testing
Secondary injection tests can pinpoint defects in a trip unit or other protective schemes ensuring that the system is functioning normally.
Read More »Pinpoint Defects in Micrologic, NT, STR Trip units with Square D S33595
Now available for rent from Protec, the GE M-PRO Test Box, is a must have when testing the health and configuration of the GE M-PACT Plus Air Circuit Breaker.The GE M-PRO Test Box is used as a means of powering up an M-PRO Plus Protection Relay – Electronic Trip Unit, simulating faults by secondary injection or for performing a forced trip of the breaker.
M-PACT Plus breaker will be in the test mode while M-PRO Plus is connected to the Test Box through the test connector.
Connect the Test Box to the M-PRO Plus via the front panel 26-pin connector using a 15-pin to 26-pin converter.
Do not test the M-PRO Plus with the charger still connected, as this will disable power to the M-PRO Plus.
The GE M-PRO Test Box may be used as a simple power box to facilitate viewing of faults (e.g. after a trip) or the
history of trips.
Read More »When Testing GE M-PACT Plus Circuit Breaker, M-PRO Test Box is a Must